Specification
* Mfr Part Number: FS27550BWN * Feature: o Support Balanced Technology Extended (BTX) based systems. o The power supplies are primarily intended for use with small form factor system designs (10-15 liters in total system volume). o 24 pin main power connector o Support Serial ATA connector o Two +12V rails in support of EN60950 240VA o Support 75 Watt PCI-Express Requirement o High efficiency o Low Ripple & Noise o Output over voltage protection o Short circuit protection on all outputs o Resetable power shut down o INTERNAL 8 cm DC fan o 100% burn-in under high ambient temperature (50°C) o Vacuum-impregnated transformer o MTBF: 100K hours at 25°C o 100% Hi-pot tested o Line input fuse protection * Input Voltage: 115 / 220-230 VAC (without PFC) or 220-230VAC (with passive PFC) * Input Frequency: 47 to 63 Hz * Input Current: 6A max at 115Vac/ 60 Hz; 3A max at 220-230 Vac/ 50 Hz * Remote ON/OFF Control: The power supply can accept a logic signal in order to enable or disable the DC output voltage, except for +5Vsb DC * Over Current Protection: The power supply is prevented from output over current * Short Circuit Protection: The short circuit on any DC output shall not cause any damage to the power supply, including the primary fuse * Output Overshoot: No output voltage shall overshoot or generate spike while PSU is turned on or turned off * Hold Up Time: 16 ms at 115Vac/60Hz, 220-230Vac/50Hz for models without PFC * Turn On Delay Time: 12 ms at 230V/50Hz for models with passive PFC * Efficiency: 70% at normal AC input and DC full load output * Withstand Voltage: 1800VAC from input to output; 1800VAC from input to ground * Standby Input Power / Green Power: During remote off condition of the powersupply unit will draw no more than 1W from the AC source (at 120Vac, 60 Hz and 230Vac, 50 Hz) when a load of 0.5W is applied to its +5VSB rail * MTBF: 100,000 hours at full load at 25° ambient, calculated per MIL-HDBK-207F
|