Specification

    * Mfr Part Number: ATX-300PA
    * Feature:
          o Complied with ATX12V 2.0 standard
          o High efficiency, low noise and ripple and reliability
          o Remote On/Off function
          o Internal 80mm 12V DC fan included
          o Noise Killer (Thermal fan speed control function)
          o Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
          o Output over voltage, short circuit, and over current protection
          o 100% Hi-pot, ATE, and burn-in tested
          o Re-settable power shut down
          o Approved by UL 60950, TUV, IEC 60950, NEMKO (CB Report)
          o Included On/Off Switch
    * Input:
          o Input Range: ±10% of 115Vrms/57~ 63Hz, ±10% of 230Vrms/47~ 53Hz, manual selection.
          o Input Current: 7A (RMS) @ 115Vrms/60Hz, 4A (RMS) @ 230Vrms/50Hz
          o Inrush Current: 80A Max cold start, 100A Max warm start measured at 115Vrms/60Hz
    * Output:
          o Total Output: 300W
          o +3.3V and +5V total output not exceed 120W
          o +3.3V is load on 20A then +5V maximum load is 10.8A; +5V is load on 20A then +3.3V maximum load is 6A
          o +12V1+12V2 total output not exceed 264W
          o +3.3V, +5V, +12V1, and +12V2 total output not exceed 286W
    * Connectors: 20/24pin Main power; 4pin P4 power; 4x Peripheral; 1x SATA; 1x Floppy
    * Dielectric Withstand: Input to frame ground 1800V AC for 1 second
    * Insulation Resistance: 20 Meg. Ohm Min.
    * Efficiency: 70% minimum measured at nominal AC main voltage with maximum load on all outputs
    * Rise Time: Less than 20mS on all outputs
    * Hold-up Time: 12ms minimum at 115V/230VAC
    * Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
    * Leakage Current: Not exceed 3.5mA
    * MTBF:100,000 hours on maximum load at +25°C
    * Dimension (WxLxH): 6 x 5.5 x 3.4 inch / 150 x 140 x 86 mm